Aggiusta la tua roba Comunità Store

Ecovacs Deebot 900 Front Bumper Replacement

Introduzione

The front bumper of the Ecovacs Deebot 900 is used to sense obstacles in its path. A malfunctioning front bumper can cause the Deebot to move in a circular fashion. Use this guide to remove or replace the front bumper on your Ecovacs 900 Deebot.

Cosa ti serve

  1. Ecovacs Deebot 900 Front Bumper Replacement, Battery: passo 1, immagine 1 di 1

    • Remove all the brushes from the Deebot.

    Modifica

  2. Ecovacs Deebot 900 Front Bumper Replacement: passo 2, immagine 1 di 1

    • Using a Phillips #0 screwdriver, remove the two 12.25 mm screws holding the battery cover in place.​

    Modifica

  3. Ecovacs Deebot 900 Front Bumper Replacement: passo 3, immagine 1 di 1

    • Remove the battery cover.

    Modifica

  5. Ecovacs Deebot 900 Front Bumper Replacement: passo 4, immagine 1 di 1

    • Using the two white straps on the sides of the battery, gently remove the battery. ​

    • Be careful not to rip out the battery cable.

    Modifica

  6. Ecovacs Deebot 900 Front Bumper Replacement: passo 5, immagine 1 di 1

    • Carefully disconnect the battery cable by pulling near the connector at the bottom of the battery compartment.

    Modifica

  7. Ecovacs Deebot 900 Front Bumper Replacement, Front Bumper: passo 6, immagine 1 di 2 Ecovacs Deebot 900 Front Bumper Replacement, Front Bumper: passo 6, immagine 2 di 2

    • Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

    Modifica

  8. Ecovacs Deebot 900 Front Bumper Replacement: passo 7, immagine 1 di 1

    • Remove the black strip on the bottom of the bumper.

    Modifica

  9. Ecovacs Deebot 900 Front Bumper Replacement: passo 8, immagine 1 di 2 Ecovacs Deebot 900 Front Bumper Replacement: passo 8, immagine 2 di 2

    • Carefully lift up the bumper untill it pops out of place.​

    Modifica

  10. Ecovacs Deebot 900 Front Bumper Replacement: passo 9, immagine 1 di 2 Ecovacs Deebot 900 Front Bumper Replacement: passo 9, immagine 2 di 2

    • Disconnect the two cables connecting the bumper to the body of the Deebot.

    • Remove the front bumper from the device.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Un commento

Where may I buy the front bumper assembly? I'm trying to replace one for a deebot 901 but the mfg tells me they don't see the part directly.

Chris Khacherian - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 38

Ultimi 30 Giorni: 214

Tutti i Tempi: 9,678