Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 9 screws with a PH2 Phillips screwdriver on the underside of the D35. The screws are:
-
7 x 14mm screws
-
2 x 10mm screws
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use spudger or plastic opening tool to separate the Deebot backside
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully lift the back cover from the body of the Deebot
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
There are 5 cables that need to be carefully disconnected before completely disconnecting the back cover:
-
The 5 cables two blue cables on the front left and right side (located next to the sensor). Represented by the red arrows.
-
Multicolor ribbon in the front center. Represented by the blue arrow.
-
Two (black and red) two prong adapter connected to the motherboard. Represented by the green arrow.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the 3 screws on the motherboard:
-
2 x 14mm screws
-
1 x 10mm screws
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the screws from the motherboard with a PH2 Phillips Head Screwdriver. The screws are:
-
2 x 14mm screws
-
1 x 10mm screws
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate and disconnect 12 cables bundles connected on the motherboard
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully disconnect the motherboard from the Deebot body.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.