Aggiusta la tua roba Comunità Store

Eco X Gear Cone Replacement

Introduzione

You will need a phillips head screw driver and needle nose pliers to complete this task. Before opening the device, ensure that there is no power to avoid damaging the electronics or harming yourself.

Cosa ti serve

  1. Eco X Gear Cone Replacement, Frame: passo 1, immagine 1 di 1

    • Disconnect any power source and/or turn off device.

    Modifica

  2. Eco X Gear Cone Replacement: passo 2, immagine 1 di 1

    • Remove the 15 rubber plugs from the cavities using needle nose pliers.

    Modifica

  3. Eco X Gear Cone Replacement: passo 3, immagine 1 di 1

    • Use a phillips head screwdriver to remove the fifteen 6.4mm screws.

    Modifica

  5. Eco X Gear Cone Replacement: passo 4, immagine 1 di 1

    • Carefully separate the two sections of the frame.

    • Wires still connect the two sections. Be cautious to avoid damaging the wires, terminals, and electronics.

    Modifica

  6. Eco X Gear Cone Replacement, Cone: passo 5, immagine 1 di 1

    • Disconnect the wiring to improve accessibility to the cones.

    Modifica

  7. Eco X Gear Cone Replacement: passo 6, immagine 1 di 2 Eco X Gear Cone Replacement: passo 6, immagine 2 di 2

    • Remove the four screws which hold down the speaker. Then, pry up the speaker from the frame.

    Modifica

  8. Eco X Gear Cone Replacement: passo 7, immagine 1 di 1

    • To replace the cone, remove the existing one by peeling it off of the speaker with needle nose pliers.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 4

Tutti i Tempi: 139