EVGA x17 Disassembly and Cleaning

Introduzione

This guide contains steps to clean and disassemble the EVGA x17 gaming mouse. To ensure easy and simple repairs follow this guide to assist in disassembling of the mouse and proper careful cleaning to eliminate troubleshooting caused by dirt and debris.

Cosa ti serve

Passo 1 Mouse

EVGA x17 Disassembly and Cleaning, Mouse: passo 1, immagine 1 di 1

Remove the mouse skates to reveal 5 screws.

Modifica

Passo 2

Use a Phillips #00 screwdriver to remove the 5 screws that secure the bottom panel

Modifica

Passo 3

Remove the weight chamber cover and clean with a Q-tip or soft fabric.

Modifica

Passo 4

Slowly slide a spudger into and around the bottom of the panel, prying until a "popping" sound is heard.
Use a Q-tip or soft fabric to clean the bottom panel.

Modifica

Passo 5

Remove the 13 screws on the interior.
There are 2 Phillips truss-head tapping screws, large circular heads, and the 11 Phillips screws from the interior.

Modifica

Passo 6

Once all screws are removed, carefully slide the middle section out and clean with a Q–tip or soft fabric.
Clean the top panel with a Q-tip or soft fabric.
Optional: you can remove clickers as well and clean them.

Modifica

Passo 7

Remove the smaller sized cross head screws from the piece labeled A29N001-C V1.0 RU 94V-0. Remove truss head tapping screws from the side of the mouse wheel.
Remove 4 screws from the piece labeled AZAC001-A V1.0.

Modifica

Passo 8

Pull transistor from the side of the mouse wheel.

Modifica

Passo 9

Carefully slide a spudger between the opaque plastic that holds the scroll wheel in place.
Pry the plastic away from the wheel, allowing for the scroll wheel to be removed.

Modifica