Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Press the gray button to release the canister.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Find and remove the four 21.5mm screws on the bottom that hold the base plate on using a T15 Torx bit.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate and remove the 21mm screws for each wheel on the ball using a T15 Torx bit.
-
Remove the plastic disc.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate and remove the five 22mm screws on each side of the ball that keep the plastic enclosure together using a T15 Torx bit.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the bottom half of the plastic sphere to reveal the motor.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully slide the motor out of its housing in the ball.
-
Cut the two wires near the side of the motor using wire cutters.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Install the new motor by splicing in the wires.
-
Annulla: non ho completato questa guida.
Altre 4 persone hanno completato questa guida.
4 Commenti
Basic but correct only mine has spade connectors on the motor so no need to cut and solder wires. The problem I found was that the main inner filter was blocked, probably by cement dust who I am guilty of! I would like to know if this is available as a spare part? I have cleaned it for now but it really needs changing.
This vacuum cleaner is based on the DC52 model. The post motor HEPA filter has the part number 922444-02 and is offered by many spart part vendors in the web. Just google Dyson 922444-02. I have made an instruction on how to replare or clean it.
very good instructions, dismantled perfectly.
great instructions, dismantled perfectly.