Aggiusta la tua roba Comunità Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

Dynex DX-WBRDVD1 Top Cover Replacement

Introduzione

This is the guide to crack into your device, almost every repair guide will need this completed first before being able to tear into the hardware below.

Cosa ti serve

  1. Dynex DX-WBRDVD1 Top Cover Replacement, Top Cover: passo 1, immagine 1 di 2 Dynex DX-WBRDVD1 Top Cover Replacement, Top Cover: passo 1, immagine 2 di 2

    • Use a Phillips #1 screwdriver to remove the four 5mm screws that connect the black outer shell to the silver back of the device.

    Traduci

  3. Dynex DX-WBRDVD1 Top Cover Replacement: passo 2, immagine 1 di 1

    • Use a Phillips #1 screwdriver to remove the two 5mm screws on the left and right side panels.

    • There is one screw on each side that secures the cover to the body of the device.

    Traduci

  4. Dynex DX-WBRDVD1 Top Cover Replacement: passo 3, immagine 1 di 1

    • Lift the black cover to a 45 degree angle from the rear of the device and pull away from the device.

    • Check that the power cord is not preventing the device from opening or closing.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 2

Tutti i Tempi: 137