Salta al contenuto principale
  1. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Use a Phillips screwdriver to remove the four 6.4 mm-long screws from the rear panel. Use a Phillips screwdriver to remove the four 6.4 mm-long screws from the rear panel.
    • Use a Phillips screwdriver to remove the four 6.4 mm-long screws from the rear panel.

  2. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Insert an opening tool into the crease where the front and rear panel meet, starting from the outside edge of either handle. Gently pry the rear panel off of the front panel until they become partially separated.
    • Insert an opening tool into the crease where the front and rear panel meet, starting from the outside edge of either handle.

    • Gently pry the rear panel off of the front panel until they become partially separated.

  3. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Use the opening tool to separate the panels by releasing the plastic clips around the perimeter of the controller. Use the opening tool to separate the panels by releasing the plastic clips around the perimeter of the controller. Use the opening tool to separate the panels by releasing the plastic clips around the perimeter of the controller.
    • Use the opening tool to separate the panels by releasing the plastic clips around the perimeter of the controller.

  4. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Lift the rear panel directly away from the controller. Do not completely remove the rear panel. It is still attached to the controller by a ribbon cable.
    • Lift the rear panel directly away from the controller.

    • Do not completely remove the rear panel. It is still attached to the controller by a ribbon cable.

  5. Questo passaggio è privo di traduzione. Aiuta a tradurlo

    Use your fingers to gently pull the ribbon cable straight out of its connector on the motherboard. Since this cable's pull tab is too small to grab with fingers or tweezers, grab the cable itself. Otherwise utilize pull tabs whenever possible.
    • Use your fingers to gently pull the ribbon cable straight out of its connector on the motherboard.

    • Since this cable's pull tab is too small to grab with fingers or tweezers, grab the cable itself. Otherwise utilize pull tabs whenever possible.

    • During reassembly, grab the ribbon cable by the blue tab and gently press the cable straight into the connector. Push the blue tab rather than the ribbon cable itself.

Linea Traguardo

Un'altra persona ha completato questa guida.

Sam Omiotek

Membro da: 25/02/2019

22.443 Reputazione

157 Guide realizzate

Team

iFixit Membro di iFixit

Community

136 Membri

15.994 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 10

Ultimi 30 Giorni: 43

Tutti i Tempi: 505