Aggiusta la tua roba Comunità Store

Drill Master Heat Gun Motor Replacement

Introduzione

The motor inside the barrel of the gun powers the fan. Use this guide to replace the motor.

Cosa ti serve

  1. Drill Master Heat Gun Motor Replacement, Motor: passo 1, immagine 1 di 1

    • Be sure the heat gun is unplugged before starting this process.

    • Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.

    • You will need a screwdriver extension.

    Modifica

  2. Drill Master Heat Gun Motor Replacement: passo 2, immagine 1 di 1

    • Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.

    • Don't try to open the casing just yet.

    Modifica

  3. Drill Master Heat Gun Motor Replacement: passo 3, immagine 1 di 3 Drill Master Heat Gun Motor Replacement: passo 3, immagine 2 di 3 Drill Master Heat Gun Motor Replacement: passo 3, immagine 3 di 3

    • Remove the barrel casing on either end by twisting and pulling each side off.

    Modifica

  4. Drill Master Heat Gun Motor Replacement: passo 4, immagine 1 di 1

    • Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

    Modifica

  6. Drill Master Heat Gun Motor Replacement: passo 5, immagine 1 di 1

    • Remove the metal casing and fan cover from the fan unit.

    Modifica

  7. Drill Master Heat Gun Motor Replacement: passo 6, immagine 1 di 1

    • Bend the metal prongs backward that connect the fan motor to the plastic cap.

    • Bending the brackets too far back can cause the brackets to break.

    Modifica

  8. Drill Master Heat Gun Motor Replacement: passo 7, immagine 1 di 1

    • Remove the plastic cap from the motor,

    • This will allow you to work only with the motor and fan.

    Modifica

  9. Drill Master Heat Gun Motor Replacement: passo 8, immagine 1 di 1

    • Remove the fan by pulling it from the motor rod.

    Modifica

  10. Drill Master Heat Gun Motor Replacement: passo 9, immagine 1 di 1

    • Remove the two 12mm screws from the plastic fan casing using PH#00

    Modifica

  11. Drill Master Heat Gun Motor Replacement: passo 10, immagine 1 di 1

    • Remove the plastic fan casing.

    Modifica

  12. Drill Master Heat Gun Motor Replacement: passo 11, immagine 1 di 1

    • Remove the metal casing from the motor and insert the new motor in its place.

    • You may have to tug a little.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Un commento

Where can I find a new motor?

jstabler38 - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 11

Tutti i Tempi: 1,446