Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Clear out drawer of any contents. This will make the drawer easier to handle, with no mess or clutter.
-
To remove, pull the drawer completely open.
-
Lift the drawer straight up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Measure the length of the internal track to the recessed part in the rear of the track.
-
Then measure the amount of bracket that needs to be removed. In our case, 2 inches will need to be removed.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the excess bracket. Make sure to remove parts of the bracket that do not contain holes. These holes are used for fasteners.
-
To cut a section, make sure you make perfectly vertical cuts for the remaining pieces to line up. To assure a straight line to cut, use a sharpie marker to mark a straight line.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Apply JB Kwikweld to the remaining pieces of bracket. Mix equal parts of the mixture.
-
Discard the removed piece from last step.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a drill with a drill bit to make necessary holes for screws to sit and fasten the bracket. Use a drill bit slightly larger than shaft of screws, but smaller than the head of the screws.
-
Install new fastener screws to the bracket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Make sure the bracket is fastened securely, make any necessary adjustments.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert wheels on both sides of the drawer bracket into the opening behind the wheel on the track located in the furniture.
-
Close the drawer and make sure it opens and closes functionally.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.