Introduzione

This guide will allow you how to access the internal components of the device.

Parti

Nessuna parte richiesta.

Flip the device to the backside, and locate the metal tab at the center of the back cover.
  • Flip the device to the backside, and locate the metal tab at the center of the back cover.

Aggiungi Commento

Lift the metal tab up, and rotate it counterclockwise. This will unlock the back case cover.
  • Lift the metal tab up, and rotate it counterclockwise. This will unlock the back case cover.

Aggiungi Commento

  • Lift the battery plate off to either insert or remove 2 AA batteries.

Aggiungi Commento

  • With the wedge side of a spudger (or a small, flat head screwdriver), remove the black rubber case support from the device body.

Aggiungi Commento

  • With the pick side of a spudger (or tweezers), peel the sticky tape from the device.

Aggiungi Commento

  • Split the front and rear panels by inserting a small pointed tool (such as a pen point or a screwdriver tip SL1.5) in the 5 plastic tabs along the sides of the device.

  • Do not remove the back panels quickly. If too much force is applied, there is a wire connection that will break.

  • CAUTION! Be careful not to force the tabs inward. This will result in broken tabs.

Aggiungi Commento

  • With tweezers (or your fingernails), carefully disconnect the wires between the PC input and the motherboard.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 6 persone hanno completato questa guida.

Ryan Green

Membro da: 17/10/2010

81 Reputazione

1 Guida realizzata

Team

Cal Poly, Team 21-30, Regan Fall 2010 Membro di Cal Poly, Team 21-30, Regan Fall 2010

CPSU-REGAN-F10S21G30

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 7

Ultimi 30 Giorni: 26

Tutti i Tempi: 4,035