Parti

Nessuna parte richiesta.

Use a large plastic opening tool along the rear panel:
  • Use a large plastic opening tool along the rear panel:

    • There are 4 clips to release.

Aggiungi Commento

Slide the cover along the plastic frame.
  • Slide the cover along the plastic frame.

Aggiungi Commento

  • Slide off the largest plastic pieces.

Aggiungi Commento

  • Bend the second small plastic piece to release it from the rubber piece.

  • Now you can slide it out.

Aggiungi Commento

  • Slide out the hard drive as shown in the picture

  • Make sure to slide as shown or you may damage the USB bridge logic board.

Aggiungi Commento

  • Remove the 4 rubber piece from the plastic frame at each corner.

Aggiungi Commento

  • Remove the rubber piece from the SATA/USB bridge logic board.

Aggiungi Commento

  • Remove both screws holding the retaining plate and the hard drive.

  • Slide the retaining plate in order to disconnect the SATA connector.

Aggiungi Commento

  • Remove both screws holding the retaining plate with the logic board.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Gaetan

Membro da: 26/12/2012

9.285 Reputazione

30 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 13

Tutti i Tempi: 1,335