Introduzione

This guide will explain how to take off the camera's exterior case.

Parti

Nessuna parte richiesta.

  1. Begin by placing the camera upside down and removing the three small center screws.
    • Begin by placing the camera upside down and removing the three small center screws.

    • All screws are the same size and length and can be used interchangably.

  2. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  3. Turn the camera on its side (Counterclockwise). Remove the two small screws on either side of the silver panel. Turn the camera 180 degrees onto its other side and remove the two small screws on either side of the silver panel.
    • Turn the camera on its side (Counterclockwise). Remove the two small screws on either side of the silver panel.

    • Turn the camera 180 degrees onto its other side and remove the two small screws on either side of the silver panel.

  4. Locate the camera's tripod mount located on the bottom of the camera. Carefully remove the camera's tripod mount and place it aside. Be careful not to lose this piece.
    • Locate the camera's tripod mount located on the bottom of the camera.

    • Carefully remove the camera's tripod mount and place it aside.

    • Be careful not to lose this piece.

    • Rotate the silver panel labeled 4x clockwise.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 4 persone hanno completato questa guida.

Alex

Membro da: 09/03/2012

172 Reputazione

3 Guide realizzate

Team

Clemson, Team 2-3, Benson Spring 2012 Membro di Clemson, Team 2-3, Benson Spring 2012

CLEM-BENSON-S12S2G3

3 Membri

6 Guide realizzate

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 1,288