Parti

Nessuna parte richiesta.

Locate the battery cover on the bottom of the camera.
  • Locate the battery cover on the bottom of the camera.

Aggiungi Commento

Place your thumb on the battery cover and push towards the arrow. The cover will release and pop open.
  • Place your thumb on the battery cover and push towards the arrow. The cover will release and pop open.

Aggiungi Commento

  • Remove the batteries from the camera.

Aggiungi Commento

  • Unscrew and remove four (3mm) screws on the right side of the camera. This will release the front and back casings.

Aggiungi Commento

  • Use your nail or a flat object to pry up the edge of the front casing. Push the casing up and back.

  • Repeat this step for the back casing.

Aggiungi Commento

  • Locate the black plastic strip under the screen above the white plastic strip.

Aggiungi Commento

  • Pull up both sides of the black piece up about a mm.

  • The black plastic piece is not meant to come all the way off, just enough to release the screen.

  • Once the piece is lifted carefully slide the screen out of the slot.

Aggiungi Commento

  • Unscrew and remove the four (6 mm) screws on the inside casing.

Aggiungi Commento

  • Pull the inner casing off of the camera.

Aggiungi Commento

  • Unscrew and remove the four (4mm) screws from the logic board.

Aggiungi Commento

  • Use a spudger to pry up all four sides of the logic board and slide it out of the camera.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Dani

Membro da: 24/06/2010

21 Reputazione

7 Guide realizzate

Team

Cal Poly, Team 3-3, Johann Summer 2010 Membro di Cal Poly, Team 3-3, Johann Summer 2010

CPSU-JOHANN-R10S3G3

2 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 790