Remove the four rubber screw covers from encircled locations.
  • Remove the four rubber screw covers from encircled locations.

  • Using a #0 tri wing screwdriver, remove the screws previously hidden below the rubber covers.

  • If you have difficulties finding this screwdriver, it is commonly sold as a Nintendo Gameboy/Wii screwdriver.

Aggiungi Commento

Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.
  • Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.

  • Be mindful of location and magnitude of applied force, so as not to damage the case.

Aggiungi Commento

Unlock the minor LCD connector by applying bilateral pressure with tweezers, as shown.
  • Unlock the minor LCD connector by applying bilateral pressure with tweezers, as shown.

Aggiungi Commento

Use fingernails to pry off minor LCD mount, as shown.
  • Use fingernails to pry off minor LCD mount, as shown.

  • Remove the minor LCD

Aggiungi Commento

Unlock the LCD main board connectors shown in red boxes on the picture .
  • Unlock the LCD main board connectors shown in red boxes on the picture .

  • Use tweezers as necessary.

Aggiungi Commento

Place finger nails on the connector tab as shown.
  • Place finger nails on the connector tab as shown.

  • Lift the connector tab up.

Aggiungi Commento

Pull/pivot the LCD main board as shown in order to remove.
  • Pull/pivot the LCD main board as shown in order to remove.

Aggiungi Commento

Use a tweezers to lift up the main LCD
  • Use a tweezers to lift up the main LCD

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Van

Membro da: 24/06/2010

7 Reputazione

16 Guide realizzate

Team

Cal Poly, Team 2-10, Johann Summer 2010 Membro di Cal Poly, Team 2-10, Johann Summer 2010

CPSU-JOHANN-R10S2G10

4 Membri

20 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 1

Tutti i Tempi: 1,135