Introduzione

This will guide you on how to disassemble the Palm Centro to get to the logic board.

Parti

Nessuna parte richiesta.

  1. Press and slide open the battery cover.
    • Press and slide open the battery cover.

    Aggiungi Commento

  2. Caution: Turn cell phone off before removing battery!
    • Caution: Turn cell phone off before removing battery!

    • Press battery to the right.

    • Then lift up battery pack to remove.

    Aggiungi Commento

    • Phone with battery removed

    Aggiungi Commento

    • Remove the touchpad pen from the top left corner on the back to reveal the last of 6 screws to be removed.

    Aggiungi Commento

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

      • Lift the rubber cap at the top right to reveal the sixth screw.

      • Caution: There is a small Palm sticker under the rubber cap. Tampering with or removing this sticker will void your warranty!

      • Remove the six screws using the T5 Torx screwdriver.

    Aggiungi Commento

    • Remove the SIM card so housing can be separated.

    Aggiungi Commento

    • Use a plastic pry tool to separate the bottom of the case to remove the small plastic insert.

    Aggiungi Commento

    • Remove the small plastic insert at the bottom of the phone.

    Aggiungi Commento

    • Continue with plastic pry tool all the way around the phone to remove the back housing.

    Aggiungi Commento

    • Carefully peel back the tape holding the speaker (left) and keyboard (right) connection tabs in place.

    Aggiungi Commento

    • Using the plastic prying tool, lift the tabs and carefully pull the contact connections out on both sides.

      • Be very careful, these electronics are delicate!

    Aggiungi Commento

    • Separate the logic board from the case by lifting and pulling out the bottom.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

Cal Poly, Team 15-49, Garner Spring 2010 Membro di Cal Poly, Team 15-49, Garner Spring 2010

CPSU-GARNER-S10S15G49

5 Membri

12 Guide realizzate

note: if you need to replace the logic board, follow this guide, insert a new board, and then follow the steps in reverse order to get a working phone.

Chelsea Barackman - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 2,921