Introduzione

With this guide you can take your MM-4 from one solid brick of a speaker to four parts and a bunch of screws. This is useful if you are replacing a bad driver, or if the connector becomes damaged and you need to replace it.

Turn the speaker face down, so the connector side is up. Remove the four #2 Philips screws on the back plate.
  • Turn the speaker face down, so the connector side is up.

  • Remove the four #2 Philips screws on the back plate.

Aggiungi Commento

Remove the foam insert to expose the two spade connectors.
  • Remove the foam insert to expose the two spade connectors.

  • Carefully separate the connectors

Aggiungi Commento

Turn the speaker so the grill side is up. Remove the four screws on the grill.  I had to use a t-10 Torx bit to remove them.
  • Turn the speaker so the grill side is up.

  • Remove the four screws on the grill. I had to use a t-10 Torx bit to remove them.

  • The grill is not glued on, but may require a bit of prying to remove.

Aggiungi Commento

Remove the four silver bolts holding the speaker in place.  These bolts also have threads inset for the grill screws to fit into. This is a pretty quick and easy teardown, not too many parts in this one.  The meyer speaker's part number is ST-164.  It's a 16 Ohm driver.
  • Remove the four silver bolts holding the speaker in place. These bolts also have threads inset for the grill screws to fit into.

  • This is a pretty quick and easy teardown, not too many parts in this one. The meyer speaker's part number is ST-164. It's a 16 Ohm driver.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

RoggeSound

Membro da: 05/06/2010

2.055 Reputazione

1 Guida realizzata

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 15

Tutti i Tempi: 5,551