/
DE
Deutsch
ES
Español
IT
Italiano
PT
Português
TR
Türkçe
JP
日本語
EN
English
FR
Français
NL
Nederlands
RU
Pусский
ZH
中文
KO
한국어
Unisciti
Accedi
Unisciti alla più grande community di riparazione al mondo
Ricambi
GuideRisposte
Modifica
Disassembling Marshall MS-2 Partner Circuit Board

Disassembling Marshall MS-2 Partner Circuit Board

MacKinley

MacKinley e 3 altri collaboratori

Ultimo aggiornamento il July 31, 2014

Nessuna stima
Moderato

Cosa ti serve

Strumenti

  1. Disassembling Marshall MS-2 Partner Circuit Board, Disassembling Marshall MS-2 Micro Amp Case Disassembly: passo 1, immagine 1 di 1

    • First be sure to turn the power switch to the off position.

    • Do this by turning the leftmost knob counter-clockwise as until the line points to "off."

    Modifica

  2. Disassembling Marshall MS-2 Partner Circuit Board: passo 2, immagine 1 di 3 Disassembling Marshall MS-2 Partner Circuit Board: passo 2, immagine 2 di 3 Disassembling Marshall MS-2 Partner Circuit Board: passo 2, immagine 3 di 3

    • Now remove the battery.

    • On the back of the device locate the battery cover.

    • Remove it by pushing down on the clip.

    • Then pull the piece of fabric until the battery comes out.

    Modifica

  3. Disassembling Marshall MS-2 Partner Circuit Board: passo 3, immagine 1 di 2 Disassembling Marshall MS-2 Partner Circuit Board: passo 3, immagine 2 di 2

    • Use the long, skinny phillips head screwdriver to remove the 4 7/16" screws on the back of the device in the four corners.

    • Once unscrewed, do not try to take each screw out. Move to next step once all screwed have been unscrewed.

    Modifica

  5. Disassembling Marshall MS-2 Partner Circuit Board: passo 4, immagine 1 di 1

    • Now pull the back panel off and place it down as shown. Pull the panel straight up so you do not lose the screws.

    Modifica

  6. Disassembling Marshall MS-2 Partner Circuit Board, Partner Circuit Board: passo 5, immagine 1 di 2 Disassembling Marshall MS-2 Partner Circuit Board, Partner Circuit Board: passo 5, immagine 2 di 2

    • Use a 9/16" socket to remove the nut around the headphone jack. Be careful to not lose the washer.

    Modifica

  7. Disassembling Marshall MS-2 Partner Circuit Board: passo 6, immagine 1 di 1

    • Remove the 7/16" phillips head screw.

    Modifica

  8. Disassembling Marshall MS-2 Partner Circuit Board: passo 7, immagine 1 di 1

    • Grab the headphone jack from inside the case and pull it toward the speaker until you can fully remove it from the device.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

1Commento della guida

There Is a toroidal transformer inside ?

Jack redmond - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 5

Tutti i Tempi: 1,938