Parti

Nessuna parte richiesta.

  1. The back panel (pictured left) has a black wire (end of wire circled red).  The wire solders to the bottom right corner of the card drive.
    • The back panel (pictured left) has a black wire (end of wire circled red). The wire solders to the bottom right corner of the card drive.

    • The front panel (pictured right) has a black and red wire (end of wired circled green). This wire solders to a small circular spot next to where the black wire connects to the back (from above).

    Aggiungi Commento

  2. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
Conclusione

To reassemble your device, follow these instructions in reverse order.

ewkpates

Membro da: 03/05/2012

123 Reputazione

1 Guida realizzata

To open the leappad top start with, remove battery covers and the 6 screws.

The two halves slide, bottom half towards cartridge slot, to make it harder they have used double sided tape on the bottom platic tounges, so a scredriver in the bottom will be needed to prize the slide.

Lawrence - Replica

Good stuff. I'm trying to slide the back plate upward, but to no avail. You mentioned tape. Where exactly is it located?

John - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 12

Tutti i Tempi: 5,518