Introduzione

This tutorial demonstrates how to remove the back cover from the camera

Parti

Nessuna parte richiesta.

Turn off camera by firmly pressing the power button that is located on the top of the camera near the selector dial.
  • Turn off camera by firmly pressing the power button that is located on the top of the camera near the selector dial.

Aggiungi Commento

Press thumb firmly on battery door and slide it in the direction of the arrow. Lift thumb allowing the door to swing open. Lift thumb allowing the door to swing open.
  • Press thumb firmly on battery door and slide it in the direction of the arrow.

  • Lift thumb allowing the door to swing open.

Aggiungi Commento

Before removing back cover, it is advisable to use an anti-static wrist strap to prevent damage to electronics.

Aggiungi Commento

Turn the camera off by firmly pressing the power button located on top of the camera.
  • Turn the camera off by firmly pressing the power button located on top of the camera.

Aggiungi Commento

Locate the 7 screws holding the back cover on. Three screws are located on the bottom of the camera. Two screws are located on the side shown in the photograph.
  • Locate the 7 screws holding the back cover on.

    • Three screws are located on the bottom of the camera.

    • Two screws are located on the side shown in the photograph.

    • Two final screws are located on the opposite side shown in the photograph.

Aggiungi Commento

Remove all 7 screws: Hold the camera firmly with one hand so that you can still see a screw. Place the Philips 00(Found here)screwdriver into the screw.
  • Remove all 7 screws:

    • Hold the camera firmly with one hand so that you can still see a screw.

    • Place the Philips 00(Found here)screwdriver into the screw.

    • Turn the screwdriver to the left until it is free.

    • Repeat for the remaining screws.

Aggiungi Commento

Use plastic opening tools to slightly open the side of the case. Insert a plastic opening tool and apply pressure to the internal three tabs at the top. The first two are near the words "3X Optical Zoom".
  • Use plastic opening tools to slightly open the side of the case.

  • Insert a plastic opening tool and apply pressure to the internal three tabs at the top.

    • The first two are near the words "3X Optical Zoom".

    • The third is near the shutter button.

Aggiungi Commento

Gently pull apart the back cover from the rest of the camera. Make sure there are no more screws or tabs keeping the cover on. Use the plastic opening tool to separate any sides still closely connected.
  • Gently pull apart the back cover from the rest of the camera.

    • Make sure there are no more screws or tabs keeping the cover on.

    • Use the plastic opening tool to separate any sides still closely connected.

Aggiungi Commento

Linea Traguardo

Un'altra persona ha completato questa guida.

Susan Marano

Membro da: 15/04/2010

297 Reputazione

7 Guide realizzate

Team

Cal Poly, Team 24-22, Regan Spring 2010 Membro di Cal Poly, Team 24-22, Regan Spring 2010

CPSU-REGAN-S10S24G22

4 Membri

10 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 2,136