Parti

Nessuna parte richiesta.

  1. Turn off the camera.
    • Turn off the camera.

      • Locate the power switch on the front of the camera below the camera lens.

      • Slide the switch to the off position.

    Aggiungi Commento

  2. Locate the 3 screws that hold the back cover to the camera.
    • Locate the 3 screws that hold the back cover to the camera.

      • One screw is located on the film opener side of the camera.

      • The other screws are located on the opposite side of the camera.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Use the Phillips #00 Precision Screwdriver and remove the screws on the back cover.

    Aggiungi Commento

    • Open the film door to remove the back cover.

      • Slide the film door lever to the left until the film door opens.

    Aggiungi Commento

    • Use a plastic opening tool to pry the case open until a small gap is present.

      • Repeat this process at the top and bottom of the film door to loosen it.

    Aggiungi Commento

    • Grab the top and bottom of the case firmly as shown.

      • Gently remove the back of the camera case with a slight twisting motion.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

David Cottrell

Membro da: 04/10/2011

58 Reputazione

5 Guide realizzate

Team

UW Stout, Team 1-2, Zhou Fall 2011 Membro di UW Stout, Team 1-2, Zhou Fall 2011

UWSTOUT-ZHOU-F11S1G2

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 4

Tutti i Tempi: 432