Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip open the antenna on the back of the device.
-
Remove the two 4.42 mm screws on the antenna cover using a T5 Torx screwdriver.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the antenna circuit board out of its case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert the pointed end of a spudger into the leftmost slit of the antenna case.
-
Push the spudger to the right.
-
Slide the antenna case out of the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two screws on the back of the outer case using a T5 Torx screwdriver.
-
These screws are 10.82 mm long.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Starting along the top, separate the front and back of the device by pushing an iPod-opening tool into the crack along each side of the case.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.
2 Commenti
This guide works for the Garmin Nuvi 660 and 670 as well.
great instructions thank you! most of it also works for the NUVI 350, this one has an extra screw that holds the circuit board, and the connectors are different. Fixed the on/off button that broke of the soldering tips by re-soldering and adding some support at the back of the switch so this can't happen again.