Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove metal sticker under the LCD screen with a spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 4 gray screw caps with the spudger. These cover the screw heads and protect from dirt or grime.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 5 10mm screws with the #00 Phillips screwdriver. These connect the back of the outer shell to the front of the outer shell.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Open battery door. This can be done by gently depressing and sliding the battery down downward.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the spudger to separate outer shells.
-
The spudger must be inserted between the shell halves to pry the edges apart.
-
Slowly work around the outside to separate the halves.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 3 5mm screws securing the circuit board to the front shell with the #00 Phillips screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slowly lift the left side of the circuit board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the USB port cable from the back side of the circuit board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide out the battery contacts.
-
Battery contacts
-
Slot where battery contacts were located
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.
Un commento
Thank you. Where is the reset button on these first generation Flip Videos (mine doesn’t have one visible on outside, must be on inside.