Disassembling Compaq Mini 110 Display Assembly

Scritto Da: alea (e 4 altri collaboratori)

Commenti: 3
Preferiti: 4
Completamenti: 4

Disassembling Compaq Mini 110 Display Assembly

Difficoltà

Moderato

Passi

Tempo Necessario

2 minuti

Introduzione

Before accessing the screen itself or the built in webcam, you must remove the display assembly from the base.

Strumenti

Acquista questi strumenti

Phillips #0 Screwdriver

6,99 US$

Compra

Parti

Nessuna parte richiesta.

Passo 1 Disassembling Compaq Mini 110 Battery

Find the battery and the battery tabs located on the bottom of the Compaq Mini.

Find the battery and the battery tabs located on the bottom of the Compaq Mini.

Traduci

Passo 2

Push the tabs inward and slide the battery out.

Push the tabs inward and slide the battery out.

Traduci

Passo 3 RAM

Find and remove the two screws on the bottom of your Compaq Mini covering the memory compartment.
- Note that the screws are attached to the panel.

Traduci

Passo 5 Keyboard

Remove the rubber pads located on the corners of your Compaq Mini.
There may be junk underneath it. This is residue left from the glue that held on the rubber pad. Just scrape it away to find the screw.

Traduci

Passo 6

Unscrew all the corner screws. There are four total, one under each rubber pad.

Traduci

Passo 7

Unscrew the screw for the bottom case located in the RAM compartment.

Traduci

Falta um passo, pois nos modelos COMPAQ MINI 110, existe um parafuso que segura o teclado, que se encontra bem escondido dentro da cavidade que encaixa a bateria.

Amilcar Correia - 24/05/2011 Replica

Passo 8

Remove the three screws in the silver tabs at the back of the keyboard. The red circles show where they are located at the back of the base under the screen.

Traduci

3 screws in red circles are actually on metal tabs in the battery compartment, 1 deeper than the other 2. There is a keyboard symbol for each of the 3 screws.

Step 8B: Lift out keyboard by pushing upwards on the 2 accessible metal tabs. This is the most difficult step. Lack of Quality Control during assembly may prevent the kevboard from lifting out without breaking!!

John - 26/05/2012 Replica

This step may be performed after battery removal. Use care when removing ribbon cable: the white clips holding the black plastic "keeper" are fragile. Reassembly possible without white clips; however, jostling may cause the ribbon to come free.

Jason L - 14/12/2014 Replica

Passo 9 Hard Drive

Remove the three screws.

Traduci

Passo 10

Pull up on the tab.

Traduci

Passo 11 Top Cover

Remove the eight screws from the plastic top cover.

Traduci

Passo 12

Pry up the top plastic cover using a spudger.
- Under the screen there are two tabs that need to be pushed in.

Traduci

Passo 13

Careful lifting up the cover because the track pad is still attached.
Remove the cable by pulling it up.

Traduci

Passo 14 Display Assembly

Take out the four screws that keep the bottom of the hinges attached to the base.

Traduci

Passo 15

Pry off the top plastic cover of the display assembly.
Note: There is adhesive tape holding the cover on.
Note: The spudger may go all the way through to the screen-side of the cover. This is ok and will not damage anything.