Introduzione

Removing the front cover allows access to the flash assembly.

Parti

Nessuna parte richiesta.

  1. Remove one 2.25mm screw on the bottom.
    • Remove one 2.25mm screw on the bottom.

    Aggiungi Commento

  2. Remove two 2.25mm screws on the right side looking from the front.
    • Remove two 2.25mm screws on the right side looking from the front.

    Aggiungi Commento

    • Remove one 4.7mm screw on the side with the AV output.

    Aggiungi Commento

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Pull off the back cover.

    • The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

    Aggiungi Commento

    • Remove the 3.9mm screw in the AV housing on the left side from the front of the camera.

    Aggiungi Commento

    • Remove one 2.25mm screw on the bottom of the camera.

    Aggiungi Commento

    • Pull off the front cover.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Jeremy Rabaino

Membro da: 10/10/2010

135 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 20-9, Maness Fall 2010 Membro di Cal Poly, Team 20-9, Maness Fall 2010

CPSU-MANESS-F10S20G9

5 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 4

Tutti i Tempi: 2,279