Introduzione

How to remove the base (bottom) cover and power light board, which must be removed to access the battery. The images and information in this guide were taken from this computer's service manual, which can be found on the product page.

Parti

Nessuna parte richiesta.

  1. After turning off the computer, use a Torx 5 screwdriver to remove the 10 screws (#2) from the computer's base.
    • After turning off the computer, use a Torx 5 screwdriver to remove the 10 screws (#2) from the computer's base.

    • Using a prying tool or a fingernail, lift up the base cover (#1).

    Aggiungi Commento

  2. Lift up the small latch which holds down the power-light board cable (#3) down. Remove the cable by pulling out sideways.
    • Lift up the small latch which holds down the power-light board cable (#3) down. Remove the cable by pulling out sideways.

    • After removing the Philips screw which holds down the power-light board (#1), remove the power light board (#2) and its cable.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

William Daniels

Membro da: 06/04/2018

678 Reputazione

6 Guide realizzate

Team

Informative Technologies Inc. Membro di Informative Technologies Inc.

Community

15 Membri

925 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 11

Tutti i Tempi: 90