Aggiusta la tua roba Comunità Store

Dell Wyse Xn0m Mouse Sensor Board Replacement

Introduzione

As one of the key features of a laptop, the mouse pad is one of the elements of the device that is most likely to suffer wear over time. The right/left click buttons are especially susceptible to wear and tear, as these are mechanical systems connected to electrical boards.

If your left-click or right-click buttons aren't working, you may need to replace the board that controls those functions. Use this guide to learn how!

Cosa ti serve

  1. Dell Wyse Xn0m Mouse Sensor Board Replacement, Mouse Sensor Board: passo 1, immagine 1 di 1

    • Flip the device over. Unscrew nine marked 7mm Phillips #1 screws.

    Modifica

  2. Dell Wyse Xn0m Mouse Sensor Board Replacement: passo 2, immagine 1 di 2 Dell Wyse Xn0m Mouse Sensor Board Replacement: passo 2, immagine 2 di 2

    • Remove the keyboard by pushing back the tabs at the marked locations with a spudger or plastic opening tool.

    Modifica

  4. Dell Wyse Xn0m Mouse Sensor Board Replacement: passo 3, immagine 1 di 2 Dell Wyse Xn0m Mouse Sensor Board Replacement: passo 3, immagine 2 di 2

    • Turn the device around so the screen is closest to you. Lift the keyboard and detach the ribbon cable with the spudger.

    • To disconnect the cable, disengage the locking tab of the ZIF connector with the spudger and pull the cable out gently.

    Modifica

  5. Dell Wyse Xn0m Mouse Sensor Board Replacement: passo 4, immagine 1 di 1

    • Remove the keyboard and set it aside. Detach the other ribbon cables with the spudger.

    • Remove five 8mm Phillips #1 screws.

    Modifica

  6. Dell Wyse Xn0m Mouse Sensor Board Replacement: passo 5, immagine 1 di 1

    • Pry open the laptop with the plastic opening tool.

    Modifica

  7. Dell Wyse Xn0m Mouse Sensor Board Replacement: passo 6, immagine 1 di 2 Dell Wyse Xn0m Mouse Sensor Board Replacement: passo 6, immagine 2 di 2

    • Under the trackpad, detach the ribbon cables with the spudger.

    • Unscrew two 3mm Phillips #1 screws and lift the board from the pegs.

    • Remove the board from the laptop.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 14

Tutti i Tempi: 599