Parti

Nessuna parte richiesta.

Slide the release latch to unlock the battery.
  • Slide the release latch to unlock the battery.

    • Flip and remove the battery from the computer.

Aggiungi Commento

Remove the screws that secure the base cover to the computer. Press the rubber tabs towards the rear of the computer to disengage the base cover.
  • Remove the screws that secure the base cover to the computer. Press the rubber tabs towards the rear of the computer to disengage the base cover.

    • Flip and remove the base cover from the computer

Aggiungi Commento

  • Remove the screws that secure the primary hard drive to the computer. Slide the primary hard -drive latch to the unlock position and pull out the hard drive from the computer.

Aggiungi Commento

  • Flex the hard-drive bracket outward and pull out the hard drive from the bracket.

  • NOTE: A rubber filler is installed to the hard-drive bracket for 7 mm hard drives. It is designed to prevent vibrations and for correct installation of the 7 mm hard drives. 9 mm hard drives do not require the filler when installed into the hard-drive bracket.

Aggiungi Commento

  • Remove the screw that secure that secondary hard drive in place.

  • Pull the tab upward and remove the secondary hard drive from the computer.

Aggiungi Commento

  • Remove the screw that secure secondary hard drive to the bracket.

  • Remove the secondary hard drive from the bracket.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Johnathan Hammond

Membro da: 28/02/2018

35.419 Reputazione

408 Guide realizzate

Team

Informative Technologies Inc. Membro di Informative Technologies Inc.

Community

15 Membri

917 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 8

Ultimi 7 Giorni: 29

Ultimi 30 Giorni: 121

Tutti i Tempi: 475