Parti

Nessuna parte richiesta.

  1. Turn the system badge fap over and place it on the base cover. Remove the screws that secure the base cover to the computer. Release and remove the base cover from the computer.
    • Turn the system badge fap over and place it on the base cover.

    • Remove the screws that secure the base cover to the computer. Release and remove the base cover from the computer.

    • NOTE: To remove the screws from the base cover, use a T5 Torx screwdriver.

    • Lift up and remove the base cover from the computer.

  2. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  3. Disconnect the battery cable from the system board [1].
    • Disconnect the battery cable from the system board [1].

    • Remove the screws that secure the battery to the computer.

    • Lift the battery off the computer [2].

  4. Pry the securing clips away from the memory module until it pops-up. Remove the memory module from its connector on the system board.
    • Pry the securing clips away from the memory module until it pops-up. Remove the memory module from its connector on the system board.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Johnathan Hammond

Membro da: 28/02/2018

35.786 Reputazione

408 Guide realizzate

Team

Informative Technologies Inc. Membro di Informative Technologies Inc.

Community

15 Membri

925 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 6

Tutti i Tempi: 72