Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Rotate the photo printer so that the bottom of the case faces upward.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #2 screwdriver to remove the three 5.65 mm screws on the bottom panel of the case in a counter-clockwise fashion.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Rotate the device so that it is upright again. Under the LCD Panel there is a 9.62 mm screw, unscrew using a Phillips #2 screwdriver.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the back panel of the case by pulling directly back.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Rotate the photo printer so that the bottom panel faces up once again. Now lift off the bottom panel of the case to access all internal components.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Finally remove the side panel with the ink-cartridge door by holding the right side and pulling backwards with the left side.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully remove the inner components of the device by lifting the inner components up and out of the casing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the red and black cable that is connecting the fan to the top of the logic board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully, remove the red and black cable from the logic board by pulling gently in order to isolate the cooling fan from the device.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.