Salta al contenuto principale

Introduzione

This guide walks through the steps of locating and removing the WLAN card on your Dell Latitude E4310 Latptop.

Parti

Nessuna parte specificata.

  1. Remove the single Phillips #1 screw. This screw will not necessarily come off of the panel. Lift up and remove with your fingernail, or a spudger, from the side of the door with the screw.
    • Remove the single Phillips #1 screw.

    • This screw will not necessarily come off of the panel.

    • Lift up and remove with your fingernail, or a spudger, from the side of the door with the screw.

  2. Remove the single Phillips #1 screw.
    • Remove the single Phillips #1 screw.

  3. Use a spudger to pry up the card. Pull the card up and out of its slot. Pull the card up and out of its slot.
    • Use a spudger to pry up the card.

    • Pull the card up and out of its slot.

  4. Pull the white and black antenna cables off of the card. Make note of these connectors (mark with a marker or pen) as they must be the right connectors for the card to work properly. Make note of these connectors (mark with a marker or pen) as they must be the right connectors for the card to work properly.
    • Pull the white and black antenna cables off of the card.

    • Make note of these connectors (mark with a marker or pen) as they must be the right connectors for the card to work properly.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 9

Tutti i Tempi: 140