Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Introduzione

By following the steps in this guide one should be able to replace the trackpad on your device (Dell Inspiron 7568)

  1. Remove the ten 7mm Phillips #1 screws on the bottom cover. Remove the bottom cover.
    • Remove the ten 7mm Phillips #1 screws on the bottom cover.

    • Remove the bottom cover.

  2. Remove the four 3mm Phillips #1 screws holding the battery. Unhinge the connector cable to the battery.
    • Remove the four 3mm Phillips #1 screws holding the battery.

    • Unhinge the connector cable to the battery.

    • Remove the battery.

  3. Kit per Nintendo Switch

    Una soluzione rapida per tornare in gioco

    Acquista Kit per Switch

    Kit per Nintendo Switch

    Una soluzione rapida per tornare in gioco

    Acquista Kit per Switch
  4. Unplug the speaker cable and remove the speakers Unplug the speaker cable and remove the speakers
    • Unplug the speaker cable and remove the speakers

  5. Unscrew & remove the two 3mm screws (using a ph1 screwdriver bit) holding the touchpad bracket Remove the touchpad bracket
    • Unscrew & remove the two 3mm screws (using a ph1 screwdriver bit) holding the touchpad bracket

    • Remove the touchpad bracket

  6. Use a nylon spudger to lift the ZIF connector tab. Gently pull the touchpad ribbon cable free. Use a nylon spudger to lift the ZIF connector tab. Gently pull the keyboard daughter board ribbon cable free. Use a nylon spudger to lift the ZIF connector tab. Gently pull the keyboard daughter board ribbon cable free.
    • Use a nylon spudger to lift the ZIF connector tab. Gently pull the touchpad ribbon cable free.

    • Use a nylon spudger to lift the ZIF connector tab. Gently pull the keyboard daughter board ribbon cable free.

  7. Remove the touchpad foil using a spudger or other ESD safe blunt-tip tool. Unscrew & remove the three 2mm wafer screws holding the touchpad. Remove the touchpad.
    • Remove the touchpad foil using a spudger or other ESD safe blunt-tip tool.

    • Unscrew & remove the three 2mm wafer screws holding the touchpad.

    • Remove the touchpad.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Yash Samant

Membro da: 22/02/2017

373 Reputazione

3 Guide realizzate

Team

USF Tampa, Team S2-G2, Lacy Spring 2017 Membro di USF Tampa, Team S2-G2, Lacy Spring 2017

USFT-LACY-S17S2G2

4 Membri

7 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 200