Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the release latch while simultaneously pulling backwards on the battery.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After removing the battery, remove the two screws (3mm Phillips #1) beneath it. These screws hold the Center Control Cover in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the laptop over to the front and open the display as far as possible.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry the Center Control Cover from the laptop. On the right there is a small divot, it is advised that you start removing the panel from here.
-
Carefully lift the Center Control Cover away from the laptop.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two screws (5mm Phillips #1) at the top of the keyboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the keyboard out and away from the laptop and lift it up to access the keyboard connector.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the connector latch that secures the keyboard cable to the connector on the motherboard and remove the cable.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the keyboard up and away from the laptop.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two screws (5.5mm, Phillips #1) from the laptop base.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove black and white wires from the WLAN that lead to the display by pulling straight up.
-
Unwind the wires so they can be freely pulled through in the next step.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the laptop over to its standard position.
-
Disconnect the Wed cable and Camera1 cable from the respective Motherboard connectors as marked. Unsecure the wires so they are loose.
-
Pull the black and white wires previously connected to the WLAN through the hole.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the Camera1 cable, the Wed cable, and the black and white wires from the routing guides.
-
Remove the four screws (5mm Phillips #1) (two on either side) that secure the display assembly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the display assembly off the computer.
-
Annulla: non ho completato questa guida.
Altre 10 persone hanno completato questa guida.
3 Commenti
wow that is really good
AWESOME, but how to know if display is faulty or some issue in the other device causing blank screen
put it back toghther, then plug in a external monitor
Feyrowan -