Salta al contenuto principale

Introduzione

Use this guide to replace the RAM if you would like to upgrade the RAM, or replace it if there is damage.

Parti

Nessuna parte specificata.

  1. Make sure the display is closed. Then, flip the computer over so that you can see the bottom cover.
    • Make sure the display is closed. Then, flip the computer over so that you can see the bottom cover.

    • Loosen the two 5 mm Phillips #0 on the upper edge of the cover.

    • These screws will stay captive to the case.

  2. Remove the two 5 mm interior screws that connect the cover to the assembly using the same Philips head screwdriver from the previous step.
    • Remove the two 5 mm interior screws that connect the cover to the assembly using the same Philips head screwdriver from the previous step.

  3. Use a spudger to remove the base cover from the rest of bottom cover.
    • Use a spudger to remove the base cover from the rest of bottom cover.

  4. Gently pull apart clips on the ends of the memory module until the memory module pops up. Gently pull apart clips on the ends of the memory module until the memory module pops up.
    • Gently pull apart clips on the ends of the memory module until the memory module pops up.

  5. Pull the RAM out at a 45 degree angle.
    • Pull the RAM out at a 45 degree angle.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Jean Whitmore

Membro da: 22/01/2015

936 Reputazione

7 Guide realizzate

Team

Cal Poly, Team 18-2, Maness Winter 2015 Membro di Cal Poly, Team 18-2, Maness Winter 2015

CPSU-MANESS-W15S18G2

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 15

Tutti i Tempi: 1,724