Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Componenti & Strumenti

Introduzione

Use this guide to replace your WLAN adaptor. You will need a Phillips #0 screwdriver and a plastic opening tool to complete this guide.

  1. First flip over the laptop to expose the back panel
    • First flip over the laptop to expose the back panel

    • Use a Phillips #0 screwdriver to unscrew all ten 7mm Phillips head screws holding the back panel in place.

  2. With a plastic spudger, carefully remove the back panel by prying each corner off individually
    • With a plastic spudger, carefully remove the back panel by prying each corner off individually

    • Slowly pick up the panel and set it aside

  3. The battery will be the largest black component in the device located near the bottom edge. Using a Phillips #0 screwdriver, unscrew the two 3mm Phillips head screws holding in the battery. The battery will be the largest black component in the device located near the bottom edge. Using a Phillips #0 screwdriver, unscrew the two 3mm Phillips head screws holding in the battery. The battery will be the largest black component in the device located near the bottom edge. Using a Phillips #0 screwdriver, unscrew the two 3mm Phillips head screws holding in the battery.
    • The battery will be the largest black component in the device located near the bottom edge. Using a Phillips #0 screwdriver, unscrew the two 3mm Phillips head screws holding in the battery.

  4. Kit cacciaviti Manta

    112 punte per ogni riparazione.

    Upgrade Your Toolbox

    Kit cacciaviti Manta

    Upgrade Your Toolbox
  5. To remove the old battery, slightly lift the bottom edge of the battery with your hands Now slowly pull the battery towards you to fully detach the battery Now slowly pull the battery towards you to fully detach the battery
    • To remove the old battery, slightly lift the bottom edge of the battery with your hands

    • Now slowly pull the battery towards you to fully detach the battery

  6. Unhook both of the wires attached to the WLAN adaptor.
    • Unhook both of the wires attached to the WLAN adaptor.

  7. Remove the 3.9mm Phillips screw using Phillips #0 screwdriver.
    • Remove the 3.9mm Phillips screw using Phillips #0 screwdriver.

    • Once the screw is removed, one end of the WLAN adaptor will raise up.

  8. Gently remove the WLAN adaptor.
    • Gently remove the WLAN adaptor.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Bo Yi Lim

Membro da: 02/04/2019

205 Reputazione

2 Guide realizzate

Team

IUPUI, Team S3-G4, Harley Spring 2019 Membro di IUPUI, Team S3-G4, Harley Spring 2019

IUPUI-HARLEY-S19S3G4

3 Membri

2 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 2

Tutti i Tempi: 61