Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
First flip over the laptop to expose the back panel
-
Use a Phillips #0 screwdriver to unscrew all ten 7mm Phillips head screws holding the back panel in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With a plastic spudger, carefully remove the back panel by prying each corner off individually
-
Slowly pick up the panel and set it aside
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The battery will be the largest black component in the device located near the bottom edge. Using a Phillips #0 screwdriver, unscrew the two 3mm Phillips head screws holding in the battery.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
To remove the old battery, slightly lift the bottom edge of the battery with your hands
-
Now slowly pull the battery towards you to fully detach the battery
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew and remove the 2 of the 3mm Phillips head screws holding the hard drive in place.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift and hold the hard drive in your left hand.
-
Use your right hand to grab hold of the black wire connector attached on the right of the hard drive.
-
Carefully pull the connector away from the hard drive to completely disconnect from the laptop.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unhook both of the wires attached to the WLAN adaptor.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 3.9mm Phillips screw using Phillips #0 screwdriver.
-
Once the screw is removed, one end of the WLAN adaptor will raise up.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the plastic opening tool, unhook the black cable as shown.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the Phillips #0 screwdriver, remove the 3.9mm Phillips screw as shown.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently raise the USB/SD Card Reader IO Circuit Board and pull the part free from the device.
-