Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip your device over so the back cover is facing you.
-
Using a Phillips #0 Screwdriver, remove the ten 7mm screws holding the back cover in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Insert a plastic opening and run it along the edge of the back cover. Do this until the entire back cover can be removed.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unscrew and remove the 2 of the 3mm Phillips head screws holding the hard drive in place.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift and hold the hard drive in your left hand.
-
Use your right hand to grab hold of the black wire connector attached on the right of the hard drive.
-
Carefully pull the connector away from the hard drive to completely disconnect from the laptop.
-
Annulla: non ho completato questa guida.
Altre 6 persone hanno completato questa guida.