Introduzione

Use this guide to replace the sound card in your computer.

Parti

Nessuna parte richiesta.

Locate the case cover latch on the back of the computer.
  • Locate the case cover latch on the back of the computer.

Aggiungi Commento

Using your index finger, slide and hold the cover latch down.
  • Using your index finger, slide and hold the cover latch down.

  • While holding the latch down, place your other hand flat on the side of the case and firmly shift the side panel to the left until it disengages.

Aggiungi Commento

  • Grab the edge of the panel and slide it away from the case until it is removed.

Aggiungi Commento

  • Lay the computer flat on its side so that you are looking down on all of the components.

  • Very important at this point you connect your antistatic wrist strap to the chassis because the computer is no longer connected to ground at the power source. There is potential for static discharge which could destroy components.

Aggiungi Commento

  • Locate the Sound Card and the screw attached to the Sound Card as shown in the picture.

Aggiungi Commento

  • Remove the 8.9 mm screw by using a Phillips #2 screw-driver.

Aggiungi Commento

  • Locate and remove the white connector on the sound card by pulling on the black cable.

Aggiungi Commento

  • Grasp the Sound Card and pull it up and out of it's slot.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 5 persone hanno completato questa guida.

Arvind

Membro da: 12/10/2011

294 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 6-10, Regan Fall 2011 Membro di Cal Poly, Team 6-10, Regan Fall 2011

CPSU-REGAN-F11S6G10

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 5

Tutti i Tempi: 4,650