Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove all seven 8 mm Philips #0 screws from the back case with a Philips #0 screwdriver.
-
Once all seven screws are removed, you can pry the case off using your fingers or a plastic opening tool.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the two hinges on the corners of the device.
-
Unscrew the 5 2mm Phillips #00 screws in the hinges.
-
Pull the hinges up and slide bottom cover out
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the two cables that connect the top panel to the device. One black, and one white.
-
Remove these two cables by grabbing the golden ends with your fingers, and gently pulling straight up.
-
Remove pin port lifting up the hinge.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the seam between the screen cover, and the top panel
-
Starting at one of the hinge corners, take a thin metal prying tool and gently insert it into the seam.
-
Gently push the tool down towards the top panel until you feel the screen cover disconnect.
-
Repeat this process all around the screen cover until it is completely disconnected from the top panel.
-