Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.
Introduzione
In this guide, we will show you how to remove and replace the wireless card.
Cosa ti serve
-
-
Loosen the five captive screws that secure the base cover to the computer base.
-
-
-
Using a plastic scribe, gently pry the base cover to release the tabs on the base cover from the slots on the computer base.
-
-
-
Using a plastic scribe, disconnect the battery cable from the system board.
-
-
-
Press and hold the power button for five seconds to ground the system board.
-
-
-
-
Slide the tabs on the NEW base cover into the slots on the computer base and snap the base cover into place
-
-
-
Tighten the five captive screws that secure the base cover to the computer base.
-
-
-
Remove the screw (M2x3) that secures the wireless card and bracket to the computer base.
-
-
-
Lift the wireless-card bracket off the wireless card.
-
-
-
Disconnect the antenna cables from the wireless card.
-
-
-
Align the notch on the wireless card with the tab on the wireless-card slot.
-
-
-
Slide the NEW wireless card at an angle into the wireless-card slot.
-
-
-
Align the screw hole on the wireless-card bracket with the screw hole on the wireless card and the computer base.
-
-
-
Replace the screw (M2x3) that secures the wireless-card bracket to the wireless card and the computer base.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.