Salta al contenuto principale

Introduzione

This guide demonstrates how to replace the Voltage Sensitivity Relay (VSR) for the DeWalt DW938.

Parti

Nessuna parte specificata.

  1. Use a torque bit screw driver to remove the T10 18.3 mm screw on the handle. Use a torque bit screw driver to remove 6 T10 21.5 mm screws on the handle. Insure power source is removed from tool.
    • Use a torque bit screw driver to remove the T10 18.3 mm screw on the handle.

    • Use a torque bit screw driver to remove 6 T10 21.5 mm screws on the handle.

    • Insure power source is removed from tool.

    • Insure blade is removed from tool.

  2. Carefully cut the safety sticker with a blade along the seam.
    • Carefully cut the safety sticker with a blade along the seam.

  3. Remove the Clam Shell from the handle unit.
    • Remove the Clam Shell from the handle unit.

  4. Lift the mechanical device off the pins of the clam shell.
    • Lift the mechanical device off the pins of the clam shell.

  5. Remove the red and black trigger wires from the brush leads with the pliers. Remove the red and black trigger wires from the brush leads with the pliers.
    • Remove the red and black trigger wires from the brush leads with the pliers.

  6. Remove the VSR trigger and the lock button. Remove the VSR trigger and the lock button.
    • Remove the VSR trigger and the lock button.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Christopher Chin

Membro da: 08/03/2017

304 Reputazione

3 Guide realizzate

Team

IUPUI, Team S4-G4, Baechle Spring 2017 Membro di IUPUI, Team S4-G4, Baechle Spring 2017

IUPUI-BAECHLE-S17S4G4

4 Membri

3 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 6

Tutti i Tempi: 206