Aggiusta la tua roba Comunità Store

DeWalt DW920 Motor Replacement

Cosa ti serve

  1. DeWalt DW920 Motor Replacement, Disassembly: passo 1, immagine 1 di 1

    • Using an H-5.0 bit driver remove the four T-10 Torx screws.

    Traduci

  2. DeWalt DW920 Motor Replacement: passo 2, immagine 1 di 1

    • Use 2 H-5.0 bit drivers to take out the main bolt and head.

    • There will be blue locktite on the tread.

    Traduci

  4. DeWalt DW920 Motor Replacement: passo 3, immagine 1 di 1

    • Carefully remove the two halves of the handle.

    Traduci

  5. DeWalt DW920 Motor Replacement, Motor: passo 4, immagine 1 di 1

    • Gently lift the motor and trigger mechanism out from the frame of the drill.

    Traduci

  6. DeWalt DW920 Motor Replacement: passo 5, immagine 1 di 1

    • Locate where the motor assembly is attached to the trigger mechanism and carefully detach the wires at their solder points.

    • Mark where the two cables was connected using a masking tape or similar.

    Traduci

  7. DeWalt DW920 Motor Replacement: passo 6, immagine 1 di 1

    • Solder the new motor assembly wires to the trigger mechanism in the same fashion that the old motor was.

    • Remember to check the markers from the step before and solder the cables on the right place.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 4 altri collaboratori

Stephen Rada

Membro da: 03/11/16

433 Reputazione

4 Guide realizzate

Distintivi: 9

+6 altri distintivi

Team

UMass Dartmouth, Team 8-2, Botvin Spring 2016 Membro di UMass Dartmouth, Team 8-2, Botvin Spring 2016

UMASSD-BOTVIN-S16S8G2

2 Membri

6 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 14

Tutti i Tempi: 809