Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four (9 mm) screws with a PH2 screwdriver.
-
Remove the two (7 mm) located with a PH2 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the device over and pry the top off with a plastic opening tool.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the ribbon cable connecting the motherboard to the button control board by gently pulling it from its connector.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove four (6 mm) screws connecting the motherboard using a J0 screwdriver.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two cables connected to the motherboard: black power cable and the red/black fan cable.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the black latch on the ZIF connector and remove the ribbon cable that attaches the digitizer to the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Raise motherboard by lifting sideways and then up to avoid the ports.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove wires attaching the piezoelectric speakers to the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the five screws securing the black plastic cover with a J0 screwdriver.
-
Lift up and out to remove.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two (3 mm) screws connecting the bracket down and pull out the reflector, using a J0 Philips Head Screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide out the power source and disconnect its cables from the power jack and the light.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the screws holding down the first speaker with a J0 screwdriver.
-
Remove the screws holding down the second speaker down.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.