Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the projector upside down to access the screws on the bottom.
-
Remove the five 7mm long screws using a #3 Phillips screwdriver at least 2 inches long.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the projector over and then remove the cover by lifting it up.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the three 6mm PH2 phillips head screws.
-
Disconnect the ribbon cable by flipping up the latch on the connector and then pull the ribbon out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Disconnect the three wire connectors. Grasp both sides of the connector and pull apart.
-
Lift the motherboard up and place it out of the way.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the five 7mm PH2 phillips head screws on the black plate and lift the plate out.
-
Lift the aluminum heat sink up to remove it from the projector.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.
Un commento
I have one of these, and it no longer projects an image. I have 12.1vdc at the motherboard where the positive and negative wire are soldered in.
After de-soldering the wires, I used my bench supply to put 12vdc to the wires, still nothing. If I apply power directly to the COB, the COB will illuminate. What is the silver component held to the heat sink? Mine is labeled ‘Kavass BW-80B 250V 5A’. I have not been able to find ANY documentation for that item to be able to determine what it is, does, or what a suitable replacement might be.