Parti

Nessuna parte richiesta.

  1. Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.
    • Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.

  2. Remove the back casing to expose the circuit board.
    • Remove the back casing to expose the circuit board.

    • Detach the gray antenna wires by gently pulling on the side closest to the circuit board.

    • Detach the speaker wire by gently pulling on the side closest to the body of the camera.

    • Remove the two 7.25 mm screws using the Ph00 head.

    • Remove the back grey speaker plate

    • Remove the speaker by gently pulling on the wire near the speaker.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Collyn Dodge

Membro da: 21/03/2018

305 Reputazione

2 Guide realizzate

Team

IUPUI, Team S4-G2, Baechle Spring 2018 Membro di IUPUI, Team S4-G2, Baechle Spring 2018

IUPUI-BAECHLE-S18S4G2

3 Membri

3 Guide realizzate

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 2

Tutti i Tempi: 61