Parti

Nessuna parte richiesta.

  1. Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.
    • Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.

  2. Remove the back casing to expose the circuit board.
    • Remove the back casing to expose the circuit board.

  3. Detach the gray antenna wires by gently pulling on the side closest to the circuit board.
    • Detach the gray antenna wires by gently pulling on the side closest to the circuit board.

  4. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  5. Detach the speaker wire by gently pulling on the side closest to the body of the camera.
    • Detach the speaker wire by gently pulling on the side closest to the body of the camera.

  6. Remove the two 4.35 mm screws on the circuit board using the Philips head PH00 screw driver.
    • Remove the two 4.35 mm screws on the circuit board using the Philips head PH00 screw driver.

  7. Detach the white plug by gently pulling on the black wires. Detach the white plug by gently pulling on the black wires.
    • Detach the white plug by gently pulling on the black wires.

  8. Remove the circuit board to expose the camera body. At the same time, you will need to feed the wires through the circuit board and out the slot in the black plate under the circuit board.
    • Remove the circuit board to expose the camera body.

    • At the same time, you will need to feed the wires through the circuit board and out the slot in the black plate under the circuit board.

  9. Gently pull on the grey wire to detach the microphone from the camera body. Gently pull on the grey wire to detach the microphone from the camera body.
    • Gently pull on the grey wire to detach the microphone from the camera body.

  10. Detach the microphone from the circuit board by gently pulling on the grey wire. Detach the microphone from the circuit board by gently pulling on the grey wire. Detach the microphone from the circuit board by gently pulling on the grey wire.
    • Detach the microphone from the circuit board by gently pulling on the grey wire.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Stanley DeLuna-Dabrowski

Membro da: 21/03/2018

127 Reputazione

1 Guida realizzata

Team

IUPUI, Team S4-G2, Baechle Spring 2018 Membro di IUPUI, Team S4-G2, Baechle Spring 2018

IUPUI-BAECHLE-S18S4G2

3 Membri

3 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 3

Tutti i Tempi: 88