Introduzione

If your Craig Electronics CMP773 battery is failing and needs replaced, this replacement guide will inform you of the steps to take when performing the replacement. Make sure you have the right tools before beginning this procedure.

  1. Remove the two 3.2 mm PH000 screws near the charging port.
    • Remove the two 3.2 mm PH000 screws near the charging port.

    Aggiungi Commento

  2. Pry the back cover from the device along the bottom edge.
    • Pry the back cover from the device along the bottom edge.

    Aggiungi Commento

    • Continue prying along the edge of the device until the back cover is free.

    Aggiungi Commento

    • Pry the battery free from the device using a plastic opening tool.

    Aggiungi Commento

    • Desolder the faulty battery wires.

    Aggiungi Commento

    • Solder the replacement battery wires to the circuit board.

    Aggiungi Commento

    • Apply adhesive between the replacement battery and the device before installation.

    Aggiungi Commento

Conclusione

Once the above steps have been successfully competed, power on the device. Enjoy your newly replaced battery.

Jacob Hampton

Membro da: 26/03/2018

145 Reputazione

1 Guida realizzata

Team

IUPUI, Team S1-G5, Harley Spring 2018 Membro di IUPUI, Team S1-G5, Harley Spring 2018

IUPUI-HARLEY-S18S1G5

6 Membri

4 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 55