Aggiusta la tua roba Comunità Store

Craftsman Model 315.10721 Table Guard Replacement

Introduzione

The table guard is essential in making sure the Craftsman Model 315.10721 makes the desired cuts. Keep in mind when performing the replacement that disassembling the table guard is time consuming.

Cosa ti serve

  1. Craftsman Model 315.10721 Table Guard Replacement, Table Guard: passo 1, immagine 1 di 1

    • Using a flathead screwdriver, remove the 1/2" flathead screw to allow the table guard to pivot.

    Traduci

  2. Craftsman Model 315.10721 Table Guard Replacement: passo 2, immagine 1 di 1

    • Pivot the table guard from its upright position to an angle.

    • Using a Phillips #1 screwdriver, remove the 1" Phillips screw and the nut on the opposite side.

    Traduci

  4. Craftsman Model 315.10721 Table Guard Replacement: passo 3, immagine 1 di 1

    • Using the Phillips #1 screwdriver, remove eight 1" Philips screws from the main case.

    • Carefully remove the main case to expose the inside of the saw.

    Traduci

  5. Craftsman Model 315.10721 Table Guard Replacement: passo 4, immagine 1 di 1

    • Remove the old table guard by gently lifting it away from the main case.

    • Replace the old table guard with the new one by placing it in the same orientation as the one removed.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Autore

con 4 altri collaboratori

Riley Hilliker

Membro da: 10/14/14

557 Reputazione

5 Guide realizzate

Distintivi: 11

+8 altri distintivi

Team

Cal Poly, Team 4-47, Amido Fall 2014 Membro di Cal Poly, Team 4-47, Amido Fall 2014

CPSU-AMIDO-F14S4G47

4 Membri

5 Guide realizzate

2 Commenti

Where can I get a replacement table guard???

Roger Coyle - Replica

Where can I get a replacement table guard for this jig saw????????

Roger Coyle - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 594