Introduzione

If the scroll wheel on your Corsair Katar mouse is not working properly, this guide will demonstrate how to replace it.

Parti

Nessuna parte richiesta.

  1. Unplug your mouse before starting.
    • Unplug your mouse before starting.

    • Flip the mouse over so the bottom is facing up.

    Aggiungi Commento

  2. Remove the three skates on the bottom of the mouse using the plastic opening tools.
    • Remove the three skates on the bottom of the mouse using the plastic opening tools.

    • Skates will be very sticky.

    Aggiungi Commento

    • Use the JIS 0 screwdriver to remove the four 5 mm screws on the bottom of the mouse.

    Aggiungi Commento

    • Detach the bottom of the mouse from the upper shell.

    • Remove the shell slowly so as not to damage the white DPI cable inside the mouse.

    • Use the plastic opening tool to detach the white DPI sensor cable from its port.

    • Alternatively, you can use your hand to remove the DPI sensor cable by wiggling it out of the port.

    Aggiungi Commento

    • Use the JIS 0 screwdriver to remove the two 5mm screws on the motherboard.

    Aggiungi Commento

    • Use the plastic opening tool to pry the white cable jack away from the motherboard.

    • Lift the motherboard away from the bottom of the mouse.

    Aggiungi Commento

    • Push the scroll wheel to the right side of the motherboard as shown, then pull it away from the board to remove.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

UW Tacoma, Team S1-G3, Cardinal Summer 2018 Membro di UW Tacoma, Team S1-G3, Cardinal Summer 2018

UWT-CARDINAL-SU18S1G3

3 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 14

Tutti i Tempi: 88