Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Firstly Disconnect battery
-
Always take the negative terminal off first.
-
'''General Tip After disconnecting the battery leave the car for about 10 mins , This lets any residual energy left in the electrical system to dissapate. It is good practise whatever the job
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate throttle body on right side of engine, it is between the intake tube and intake manifold.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide both slackened cables off assembly’s guides.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the two hoses on the top of the throttle body.
-
Gently lift the hoses off.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a flat head screwdriver to loosen the hose clamp attaching the intake tube to the throttle body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the intake tube from the throttle body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate wiring clip on the underside of the throttle body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Press down on the locking mechanism before gently removing the wiring clip.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate throttle linkage arm.
-
Open the locking clip with a flat head screwdriver.
-
Pry off the linkage arm with a flat head screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the three 13mm nuts attaching the throttle body to the intake manifold.
-
Remove nuts with a 13mm crescent wrench.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the throttle body off of the intake manifold.
-
The manifold is now out of the engine bay and ready for cleaning or adjustment.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Cover the electrical contacts with a shop towel to prevent throttle body cleaner from inadvertently spilling over.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Liberally apply throttle body cleaner to the inside of throttle body and butterfly valve.
-
Use a shop towel sprayed with cleaner to wipe off thick grime if severely dirtied.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Spray electrical cleaner on the metal contacts to blast away particles in the bracket.
-
Spray off the wiring clip that attaches to the throttle body inside the engine bay.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Apply a small amount of dielectric grease to the metal contacts to prevent corrosion.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.