Salta al contenuto principale

Introduzione

Disassembly guide for Cisco Aironet 1242ag Access Point

Strumenti

Parti

Nessuna parte specificata.

  1. The equipment cover is held by 4 screws. The equipment cover is held by 4 screws.
    • The equipment cover is held by 4 screws.

  2. Once the 4 screws are removed, push to the side to remove the cover.
    • Once the 4 screws are removed, push to the side to remove the cover.

  3. The card is attached to the bottom plate by 4 screws Before removing the logic board, disconnect the antenna cables in both parts of the device. There is a total of 4 cables. Use a tweezer or a spudger to disconnect them.
    • The card is attached to the bottom plate by 4 screws

    • Before removing the logic board, disconnect the antenna cables in both parts of the device.

    • There is a total of 4 cables. Use a tweezer or a spudger to disconnect them.

  4. Write the wisdom here. Write the wisdom here. Write the wisdom here.
    • Write the wisdom here.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Un ringraziamento speciale a questi traduttori:

100%

Questi traduttori ci stanno aiutando ad aggiustare il mondo! Vuoi partecipare?
Inizia a tradurre ›

Documenti Allegati

Eneider Colina

Membro da: 20/09/2013

1.442 Reputazione

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 14

Tutti i Tempi: 321